– 10 –
QUICK VIEW OF SYSTEM FUNCTIONS
QUICK VIEW OF SYSTEM FUNCTIONSQUICK VIEW OF SYSTEM FUNCTIONS
QUICK VIEW OF SYSTEM FUNCTIONS
REMOTE PHONE CONTROL OPERATION
To remotely disarm: --------------------------------- + [1]
To remotely arm in AWAY mode: -------------- + [2]
To remotely arm in STAY mode: --------------- + [3]
To remotely arm in AWAY or STAY mode with NO DELAY: + [2] or [3] + [0]
To remotely activate X10 devices 01-06: ---- [#] + [4] + (2-digit) device no.
To remotely activate X10 devices 07 & 08:- + [#] + [4] + (2-digit) device no.
To remotely deactivate X10 devices 01-06: [#] + [7] + (2-digit) device no.
To remotely deactivate X10 devices 07 & 08: + [#] + [7] + (2-digit) device no.
To remotely bypass a zone: ---------------------- + [6] + zone no.
To remotely activate forced bypass: --------- + [6] + [#]*
To remotely check system status: ------------- [*]
To hang up: ---------------------------------------------- + [9]
*If forced bypass was enabled by your installer.
OTHER FUNCTIONS
To set the time and date: -------------------------- + FUNCTION + [63]
To set scheduling: ------------------------------------ + FUNCTION + [64]
To activate X10 devices 01-06:------------------- FUNCTION + LIGHTS ON + (2-digit) dev. no.
To activate X10 devices 07 & 08: +FUNCTION +LIGHTS ON + (2-digit) dev. no.
To deactivate X10 devices 01-06:................... FUNCTION + LIGHTS OFF + (2-digit) dev. no.
To deactivate X10 devices 07 & 08: +FUNCTION +LIGHTS OFF + (2-digit) dev. no.
To add a user code:
**
+ CODE + user no. (02-08)+ user code
To delete a user code (except Master Code): .....
**
+ CODE + user number (02-08)
To turn Test mode on: ------------------------------ + TEST
To turn Test mode off: ----------------------------- + OFF
To use the defined AUX function: - Press and hold AUX key 2 seconds (4 beeps) +
To send message to pager: ------------ Press and hold AUX key 2 seconds (4 beeps)
To program “Follow Me” reminder phone no: +FUNCTION + [65] + Enter up to 24
digits
To delete “Follow Me” reminder phone no: + FUNCTION + [65]
** Only the master code can be used to add or delete another user code.
To Next Page
Loading...
Need help?
General
