– 28 –
USER FUNCTIONS
USER FUNCTIONSUSER FUNCTIONS
USER FUNCTIONS
Message Recording/Playback/Volume Control
Adjusting the Volume
The volume level of message playback, system announcements, and status beeps can be changed. You
can also mute system announcements if desired. See NOTE below if using a wireless keypad.
To adjust message playback/system announcement volume:
FUNCTION + VOLUME + [3] or [6] †
† [3] = increases volume one level, [6] = decreases volume one level.
Repeat the key sequence until the desired volume level is achieved.
To mute system announcements:
FUNCTION + VOLUME + OFF
When muted, no system announcements will be made. Recorded messages will be announced, though,
when
PLAY is pressed.
To restore announcement sounding: FUNCTION + VOLUME + [3] or [6]
Volume level will be restored to the level that was selected prior to muting the sound.
NOTE: If a wireless keypad (5827) has been installed and is programmed for quick arming, it cannot be
used to activate message playback or adjust the volume. In this case, you must use the master
keypad to perform these functions.
To Next Page
Loading...
Need help?
General
