To Next Page

To Previous Page

– 42 –

FIRE ALARM SYSTEM

FIRE ALARM SYSTEM FIRE ALARM SYSTEM

FIRE ALARM SYSTEM (If Installed)

General Information

ULUL

Lynx Plus Series is not intended for UL985 Household Fire applications unless a 24-hour backup

battery (P/N LYNXRCHKIT-HC or LYNXRCHKIT-SHA) is installed.

General

Your fire alarm system (if installed) is active 24 hours a day, providing continuous protection. In the

event of an emergency, the installed smoke and heat detectors will automatically activate your security

system, triggering a loud, intermittent sound from the keypad. An intermittent sound will also be

produced by optional exterior sounders, and interlaced with the voice descriptor, sounding every 15

seconds. A “Fire” message will appear at your keypad and remain on until you silence and clear the

alarm display.

In Case of Fire

1. Should you become aware of a fire emergency before your detectors sense the problem, go to your

nearest keypad and press the single panic key (or panic key pair) assigned as FIRE emergency (if

programmed by the installer) and hold down for at least 2 seconds. The alarm will sound.

2. Evacuate all occupants from the premises.

3. If flames and/or smoke are present, leave the premises and notify your local Fire Department

immediately.

4. If no flames or smoke are apparent, investigate the cause of the alarm. The zone number of the

zone(s) in an alarm condition will appear at the keypad.

Silencing a Fire/Carbon Monoxide (CO) Alarm

1. Silence the alarm by entering: + OFF key.

Your user code

NOTE: Silencing a fire or CO alarm on the LynxSIA Plus Control simply requires you to enter your user

code. Pressing the OFF key is not necessary. To clear the alarm however, you must enter your

user code again and then depress the OFF key.

To clear the alarm display, enter: + OFF key again.

Your user code

2. If the keypad indicates a trouble condition after the second OFF sequence, check that smoke

detectors are not responding to smoke- or heat-producing objects in their vicinity. Should this be

the case, eliminate the source of heat or smoke.

3. If this does not remedy the problem, there may still be smoke in the detector. Clear it by fanning

the detector for about 30 seconds.

4. When the problem has been corrected, clear the display by entering:

+ OFF key.

Your user code

Honeywell Lynx Plus Series User Manual

Other manuals for Honeywell Lynx Plus Series