To Next Page

To Previous Page

–38–

✻

85 Record Custom Voice Descriptors

Use this mode to record up to 5 custom voice descriptors. Press ✻85 while in Programming mode.

Note: Entering a number other than one specified will give unpredictable results.

Assign custom voice descriptors

0 = exit mode

1 = enter mode

Entering “1” advances to the next prompt below.

Entering “0” exits mode, upon which this prompt blinks, indicating the

mode is inactive.

A 7d

Custom descriptor number

Enter 7 + d + [✻]

Where d = 0-4, each representing custom

word 70, 71, 72, 73, or 74, respectively. Any

existing word will be announced.

Press [#] to start recorder. Begin speaking

immediately after the third beep.

Speak the desired word clearly near the

microphone. Recording stops after 1.5

seconds.

6 = accept word and ready to record next

descriptor prompt (A….7d)

[#] = re-record descriptor

00 = exit Record mode after pressing 6 to

accept word

Press any key to repeat the recorded word.

Record up to 5 custom words.

Honeywell LYNXR User Manual

Other manuals for Honeywell LYNXR