PAGE - 4 Installation manual LCD6000
NOTIFIER ITALIA Doc. M-184.1-LCD6000T-ENG Rev A.2 LCD6000_manu
CONTROLS ON THE FRONT PANEL
PASSWORD LEVEL 2
To enter the password input is sufficient to hold the reset button, or, press key and then, with the arrow
keys
select “local programming”.
With the arrow keys
select the first figure, press "ENTER" to confirm and move to the inclusion of
the next figure.
Repeat this action until a final digit.
The level 2 password by default is 22222
SIGNALLINGS ON THE FRONT PANEL
PRE-ALARM1 (Red):
It flashes if there is at least a technological type device in un-recognized Pre-alarm-1
condition (the P1 threshold is set in the control unit on the devices which are programmed
with Type-ID “TEC2” or “TEC3”).
It is permanently lit if all Pre-alarm-1 events have been recognized.
PRE-ALARM2 (Red):
It flashes if there is at least a technological type device in un-recognized Pre-alarm -2
condition (the P2 threshold is set in the control unit on the devices which are programmed
with Type-ID “TEC2” or “TEC3”).
It is permanently lit if all Pre-alarm-2 events have been recognized.
ALARM (Red):
It flashes if there is at least a technological type device in un-recognized Pre-alarm-2
condition (the AL threshold is set in the control unit on the devices which are programmed
with Type-ID “TEC2” or “TEC3”). It is permanently lit if all Alarm events have been
recognized
BUZZER SILENCING: by pressing this key, you
can silence the LCD6000T panel buzzer and you can
perform the RESET control.
RESET: by pressing this key, you can cancel
the memory of current alarms or breakdowns of
points. It deactivates the sirens and switches off
all light signallings of the alarm sensors.
To perform this operation the level 2 password
must be known.
ARROWS: selection keys.
LISTS: this key has a double operating mode:
1) the simple pressure of this key allows entering the adjacent
folders (displays)
2) in case of alarm zone or breakdown zone events, it allows to
display the list of each alarm or breakdown point
MENU: by pressing this key the user can access both
the LDC6000T panel programming menu and the
display functions of the excluded points and zones.
To Next Page
Loading...
Need help?
General
