6
(D) TECHNICAL INFORMATION
In-the-ear product.
Material of neckband: PC/ABS/TPE.
Material of ear piece: Metal.
Material of cables: xxx.
Weight: xxx g.
Replacement eartips: Contact your distributor or sales representative
INFORMATION ABOUT THE FREQUENCY BANDS AND POWER USED
BY RADIO EQUIPMENT:
The product is equipped with Bluetooth Low Energy that operates in the frequency range 2.402 to
2.480 GHz. Maximum output power 4.0 dB .
Product is Bluetooh SW5.0 compliant. Supported Bluetooth profiles are Hands Free Profile,
Headset Profile, Advanced Audio Distribution Profile and Audio Video Remote Control Profile.
PATENTS
Patents pending. For patent information, see http://www.honeywellaidc.com/patents
FCC AND INDUSTRY CANADA STATEMENTS
COMPLIANCE STATEMENT
VS332i complies with Part 15 of the FCC Rules and Industry Canada Licenseexempt RSS
standard(s). Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
WARNING
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules and Industry Canada License-exempt RSS standard(s). These
limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help
/* MPE (SAR) CALCULATION */
This device contains radio transmitters and has been designed, and tested to meet the FCC and
Industry Canada License-exempt RSS standard(s) for RF exposure and Specific Absorption Rate.
To ensure that your exposure to RF energy generated by the radio transmitters does not exceed
the exposure limits set forth by these guidelines, the device must be used in accordance with the
supplied User Instructions.
To Next Page
Loading...
General