ClEANER MAINTENANCE
Emptying the Dust Container
Press the dust container release button and pull the dustbin forwards to remove it from the main body
of the cleaner. [6]
Hold the unit over a bin and push the bin empty slider to empty the dust container. [7]
Return the dust container to the cleaner main body. [8]
Cleaning the Filters
Press the dust container release button and pull the dust bin forwards to remove it from the main body
of the cleaner. [6]
Pull the lter and shroud assembly from the dust bin using the grips on the lter frame. [9]
Twist the lter anticlockwise to remove it from the shroud. [9]
Wash the lter in lukewarm water and leave to dry for 24 hours. Once thoroughly dry reassemble to the
shroud and dustbin. [10]
If required, wash the dustbin in lukewarm water. Ensure it is fully dry before returning to the main body
of the cleaner. [13]
Return the dust container to the cleaner main body. [8]
NOTE: Do not use hot water or detergents when cleaning the lters. In the unlikely event of the lters
becoming damaged, t a genuine Hoover replacement. Do not try and use the product without a lter tted.
IMPORTANT: For optimum performance, always keep your lter clean. We recommend that the lter
should be washed once a month.
DISPLAY LED*
This cleaner is equipped with a LED display. When the product is on, the display will report the following
information:
BATTERY LEVEL INDICATOR*:
• 4 bars = 100% charge
• 3 bars = 75% charge
• 2 bars = 50% charge
• 1 bar = 25% charge
When the batteries are empty the last battery level indicator will ash for 20 seconds before the product
switches o automatically.
TURBO: When the Turbo mode is activated on the ergonomic handle, the Turbo icon will light in blue.
CHARGE INDICATOR: When the product is charging, the battery icon will ash every 1 seconds. When
fully charged, the icon will stop ashing and remain lit while the charger is plugged in. The icon will switch
o when the cleaner is in use.
USINg yOUR ClEANER
Turn the cleaner on by sliding the ON/OFF switch forwards to one of the following settings: [5]
• FLOOR : ideal for hard floor surfaces. Normal power without power brush rotation. [B2]
• CARPET: ideal for carpets and rugs. Normal power with agitator. [B3]
• TURBO: press Turbo button for full power on either floor or carpet mode. The Agitator will rotate
at maximum speed. [C]
3
GB
* Certain Models Only