4. Cleaning Carpet
1+
2o
,,
4,,
5,
,
9,
IOn
Io
12.
t4.
15..
I&
17,
Remove lightweight furniture (tables, lamps, etco} from area to be cleaned.
Protect any remaining furniture by pinning up furniture skirts and placing aluminum foil or
plastic under legs,
Vacuum carpet thoroughly to remove loose dirt, hair, lint and other debris,
Test detergent for colorfastness on a hidden area of carpet.
Wet a white cloth or paper towel with some detergent. Gently rub onto
a hidden area of carpet. Wait ten minutes.. Blot with white cloth or paper
towel and check for color transfer,
Pretreat spots, stains and high traffic areas with Hoover Spot and Stain
Spray,,
Spray spot or area with Spot and Stain Spray. Then proceed with the next
cleaning steps, Fig. 4.t
For stubborn spots oT stains, refer to the stain guide included with
your cleaner.
Fillsolution tank with hot tap water and proper amount of Hoover detergent
(see Page 6)..
Use only Hoover brand detergents in your carpet cleaner. Other brands
may damage the carpet cleaner..
Plan your cleaning to avoid walking on wet carpet. Start at the end of
the room farthest from the exit and work in small sections+ Fig. 4.2
Step on handle release pedal and lower handle, Turn cleaner ON.
Squeeze and hold trigger [A) to release cleaning solution_ Push cleaner
forward SLOWLYthen pull it back SLOWLY,Fig. 4°3
Let go of trigger and push cleaner over same area to pick up dirty
solution without putting down more solution. Continue using dry
strokes until you see only a little solution coming up through the nozzle
[front of cleaner)°
Exit
Do not make the carpet too wet! Use no more than two sets of Forward
and backward strokes while releasing solution. Always follow with dry
strokes - the more the better°
A
Listen carefully! When the motor sound changes (rises in pitch), the recovery tank needs to
be emptied.
When water has reached the full line in the recovery tank, the cleaner win NOT pick up
dirty solution+
18, Allow carpet to dry, Avoid walking on the carpet until it is dry,
19. Increased air circulation (open doors, turn on fans, etc,) will help carpet dry thoroughly to
prevent the growth of mold or mildew.
20. Vacuum thoroughly after carpet has dried This will reduce any shading left by the carpet
cleaner's brushes°
to
To Next Page
Loading...
Need help?
General
