Hoover Carpet Cleaner User Manual

6. Maintenance
Unplug the carpet cleaner frmn electrical outlet before servicing,
Clean
p
2,.
3,
p
5,
the Nozzle
Remove solution and recovery tanks to prevent possible leaks.
l..if'tup on top of' nozzle {A)and slide off cleaner, Fig_ 6,t
Wipe debris off nozzle and front of cleaner with a damp cloth°
Tilt cleaner back, raising front of cleaner off floor. Slide nozzle (B] up
from bottom of cleaner, Fig, 6.2
P_'ess on upper portion of nozzle to snap in place.,
Clean the Brushes
['_, Remove solution and recovery tanks to prevent possible leaks.
Z Tilt cleaner back so handle rests on the floor,
-3o Pull brush assembly firmly to remove, Fig,,6,3
4, Rinse brushes under running water,
_, Align posts (Q on brush assembly with slots (D) in cleaner. Turn
brushes slightly to align square post (E) with square hote (F) in cleaner.
Fig. 6,4
6. Press brush assembly firmly and snap in place_
Clean
1.
3.,
4.
5,
the Brush Filter
Remove solution and recovery tanks to prevent possible leaks.
Tilt cleaner back so handle rests on the floor:
Squeeze Filter Frame (G) and pull it out until it stops. Fig, 6°5
Wipe debris off filter.
Slide filter back into place,
Storing
2.
7.
4o
Your Carpet Cleaner
Empty solution tank and rinse thoroughly.,
Place empty solution tank on carpet cleaner, Turn carpet cleaner ON.
Squeeze trigger and push carpet cleaner forward and back several
times, This will clear any solution remaining inside the cleaner,
Empty recovery tank, rinse thoroughly and let air dry.
Allow brashes and underside of carpet cleaner to air dr_ thoroughly
before storing carpet cleaner on a carpeted or wood surface.
_i k .
A"
L
E
DF
6
Lubrication
The motor is equipped with bearings which contain sufficient lubrication
for the life of the motor, The addition of lubricant could cause damage.
Do not add lubricant to motor bearings,,
12

Hoover Carpet Cleaner Specifications

General

Brand	Hoover
Model	Carpet Cleaner
Category	Floor Machine
Language	English