Hoover Dynamic Next WDMT413AI2 User Manual

!
EN
25
! Press for at least 1 second the ON/OFF
button to switch on the appliance.
! Press the DRYING PROGRAMME
SELECTION button to select the more
suitable drying programme for your
laundry.
! Press the DRYING SELECTION button to
select the degree of dryness that you
require, choosing one of 3 automatic
programmes:
Extra dry programme (suitable for
towels, bathrobes and bulky loads).
Iron dry programme (that leaves the
laundry ready for ironing).
Cupboard dry programme (for
items that will be put away without
ironing).
! If you wish to select a timed drying
programme, press the DRYING
SELECTION button until the required
time indicator lights up.
! Make sure that the water inlet valve is
open.
! Make sure water drain is correctly
positioned.
! Press the START/PAUSE button.
! The drying programme indicator will be
on, until the cool down phase begins and
the corresponding indicator is on.
! When the programme is finished the word
"End" will appear on the display. After
5 minutes the appliance will go into
standby mode (on certain models, the
display will show two lines).
! After the programme has finished please
wait for about 2 minutes until the DOOR
LOCKED indicator has gone out before
opening the door.
! Press for at least 3 seconds the ON/OFF
button to switch off the appliance.
! Open the door and remove the laundry.
! Turn off the tap.
CANCELLING THE DRYING PROGRAMME
! To cancel the drying programme, press
and hold the DRYING SELECTION
button for about 3 seconds.
WARNING:
Do not dry woollen garments or
articles with special padding (e.g.
quilts, quilted anoraks, etc.) and very
delicate fabrics. If garments are
drip/dry, load less items as to prevent
creasing.
WARNING:
After cancelling the drying programme,
the cool down phase will begin and you
must wait for about 10/20 minutes
before opening the door.

Hoover Dynamic Next WDMT413AI2 Specifications

General

Brand	Hoover
Model	Dynamic Next WDMT413AI2
Category	Washer/Dryer
Language	English