USINGTHESOLUTIONCONTROLDIALANDADJUSTINGTHESOLUTION
• The Solution Control Dial controls the amount of cleaning solution that is added to the steam. It does
not adjust the amount of steam, only the cleaning solution.
• If you wish to clean with steam alone, simply turn the Solution Control Dial to "STEAM ONLY". Now
every time you press the Steam Trigger, you will release steam alone.
• If you wish to clean using cleaning solution, simply turn the Solution Control Dial to the desired
setting. Now when pressing the Steam Trigger, the steam mop will release the amount of cleaning
solution that is indicated on the Solution Control Dial as well as a steady flow of steam.
STEAMCLEANINGHARDFLOORS
• Attach Microfiber pad. Plug in and press the
power button on the steam cleaner (2.13).
• The steam cleaner will take roughly 30
seconds to be ready to produce steam.
Once steam is ready to be produced, the
green "steam ready" indicator will illuminate.
• To recline the steam cleaner place foot on
Mop Head and gently pull handle backwards
(2.14).
• To produce steam squeeze the Steam Trigger
(2.15).
• Move the Steam Mop slowly backwards and
forwards across the floor (2.16) paying
particular attention to high traffic areas.
ToDisinfectHardSurfaces
• Use steam alone. Do not use cleaning
solution. Turn Solution Control Dial to "STEAM
ONLY".
• Connect the hard floor Microfiber Pad (see
2.6, A) and run a minimum of 4 strokes at a
medium pace (5-7 seconds per 32" stroke)
across same area. Allow to air dry.
To Next Page
Loading...
Need help?
General
