Familiarizeyourselfwiththesehomemaintenancetasks as proper use and care
of your cleaner wflJ ensure continued cleaning effectiveness.
The System Check Indicator located at (A), alerts you to possible system
performance issues. Please refer to the Troubleshooting section on page 12 for
possible causes and solutions.
Any other servidng shou)d be done by an authorized service representative,
,A NOTICEA
An internal thermat protector has been designed into your cleaner to protect it from overheating. When
the thermal protector activates the cleaner witll stop running.
If this happens proceed as foffows:
1. Turn cleaner OFF and disconnect it from the electdcal outlet.
2. Empty dirt cup.
3. Inspect the nozz_e/brushrolI0 filters, umbrella tube and hose for any obstructions. Clear obstructions
if present.
4. When cleaner is unplugged and motor cools for 30 minutes, the thermal protector will deactivate
and cleaning may continue.
If the thermaf protector continues to activate after foflowing the above steps, your cleaner needs
servicing.
DIRT CUP
CAUTION
To reduce the risk of injury from moving parts,
unplug vacuum before servicing.
Do not operate cleaner without either the dirt
cup or filters in ptace.
How to Empty
3.2 Push dirt cup release button on top of dirt cup to
remove dirt cup.
3.3 Hold dirt cup over garbage can and press dean
release dirt cup button to empty. Make sure cup
bottom center opening is clear of debris. Snap
dirt cup bottom back into pIace after emptying.
9 Actual model may vary from images shown,
To Next Page
Loading...
Need help?
General
