2.1
VACUUM DESCRIPTION
2.2
2. HOW TO USE
1. Handle
2. Dirt Cup Release Button
3. Carry Handle
4. System Check Indicator
5. Rinsable Filter Access
6. Dirt Cup
7. Filter made with HEPA media
8. Height Adjustment
9. Furniture Guard
10. Adjustable Dusting Brush
11. Wand
12. Crevice Tool (inside wand)
13. Cord Rewind Pedal
14. Brushroll ON/OFF Pedal
15. Handle Release Pedal
16. Hose
17. Turbo Tool
18. ON/OFF Switch
19. Hose Release Button
20. Hose Connecting Tube
ON-OFF SWITCH
9
15
6
1
2
3
5
7
16
2.3
10
12
6
Actual model may vary from images shown.
4
8
13
14
17
A
C
2.4 To adjust height setting, PUSH DOWN and TURN knob (C)
to desired height setting.
For maximum cleaning performance, the following carpet
height settings are recommended:
• Hard floor setting: for use on hard floors only.
• Low through High settings: Adjust depending on
carpet type.
• For high pile carpet, use high carpet setting to
ease pushing effort.
2.4
If the vacuum is difficult to push, push down and turn
knob to the next higher setting.
CARPET HEIGHT ADJUSTMENT*
IMPORTANT
IMPORTANT
19
20
11
18
CORD RELEASE
*Number of height settings vary per model.
2.3 Prior to using, grasp the
end of the plug and pull to
release the cord from the
cord reel until red tape is
reached.
When pulling on the cord, yellow tape will identify when
the cord is almost fully extended. When red tape is visible
on the cord, the cord has reached its full length. (Do not
pull the cord past the red tape.)
2.2 Plug cord into electrical
outlet.
To turn vacuum ON (I=0N),
push ON/OFF switch (A) to
ON position.
To turn vacuum OFF
(O=OFF), push switch to OFF
position.
To Next Page
Loading...
Need help?
General
