3
STEP 1 Attach rack and handle
Carton contents
Remove all parts from carton and identify each item
shown. Make sure all parts are located before disposing
of packing.
A. Handle section
B. Cleaner body
C. Hose rack
D. Hose, cleaning tools and wands
E. Handle bolts and nuts packet
(in bag with owner’s manual)
A
A
B
C
D
E
This cleaner was inspected and packaged carefully before being shipped from the factory.
If you should happen to need assistance during assembly or operation,
Visit us online at www.hoover.com to find the service outlet nearest you (click on
the “Service” button) OR
Call 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S. only)
OR
Call 1-330-499-9499 to speak with a representative in our Consumer Response Center.
Continued
➜
1. Assembling cleanerNot
Note: The white switch lock above the ON/OFF
switch aids in the assembly of your cleaner. Assembly
can be continued if the switch lock is missing.
However, do not remove the switch lock until
assembly is completed.
Open tool cover on handle section
(A).
1-2
Attach hose rack to handle section
by fitting hooks (B) on rack over
slots (C) on handle section.
Align hole on rack with circular tab
on handle.
C
B
1-4
1-3
1-1
To Next Page
Loading...
Need help?
General
