EasyManuals Logo
Home>Hotpoint>Cookers>CH60GCIW

Hotpoint CH60GCIW User Manual

Hotpoint CH60GCIW
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
6
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the
adjustment conditions are compatible. The adjustment conditions for this appliance are stated on the data badge
which is fitted on the back panel.
This appliance is not designed to be connected to a combustion products evacuation device. It must be installed
and connected in accordance with current installation regulations. particular attention should be given to the
relevant requirements regarding ventilation.
MODEL NUMBERS CH60GCIK; CH60GCIS; CH60GCIW
Category II2H3+ (GB)
These models are set to burn NATURAL GAS (G20) at 20 mbar but can be converted for use on BUTANE (G30)
at 28-30mbar or PROPANE (G31) at 37mbar with the use of the LPG conversion kit that can be obtained free of
charge, if you contact our Genuine Parts and Accessories department (see Key Contacts, back page).
GAS SAFETY (INSTALLATION & USE) REGULATIONS
It is the law that all gas appliances are installed by competent persons in accordance with the current edition of the
above regulations. It is in your interest and that of safety to ensure compliance with the law.
In the UK, Gas Safe registered installers work to safe standards of practice. The cooker must also be installed in
accordance with BS 6172. Failure to install the cooker correctly could invalidate the warranty liability claims and
could lead to prosecution.
LOCATION
The cooker may be located in a kitchen, kitchen/diner or a bed-sitting room, but not in a room containing a bath or
shower. The cooker must not be installed in a bed-sitting room of less than 20m
3
.
When adjusted for use on Butane (G30) or Propane (G31), the cooker must not be installed in a room or internal
space below ground level, e.g. in a basement.
PROVISION FOR VENTILATION
The room containing the cooker should have an opening window or equivalent and some rooms may require a
permanent vent. For details refer to BS 5440: Part 2 (UK) or I.S. 813 (Republic of Ireland).
The room must have an opening window or equivalent; some rooms may also require a permanent vent. If the
room has a volume between 5 and 10m
3
, it will require an air vent of 50cm
2
effective area unless it has a door
which opens directly to outside. If the room has a volume of less than 5m
3
, it will require an air vent of 100cm
2
effective area. If there are other fuel burning appliances in the same room, BS 5440: Part 2 should be consulted to
determine air vent requirements.
INSTALLATION INSTRUCTIONS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hotpoint CH60GCIW and is the answer not in the manual?

Hotpoint CH60GCIW Specifications

General IconGeneral
Control typeButtons, Rotary
Handle colorStainless steel
Product typeFreestanding cooker
Product colorWhite
Built-in displayYes
Control positionFront
Hob typeGas
Wok burnerNo
Cover materialSteel
Cooking zone 1 power2000 W
Cooking zone 3 power3000 W
Number of cooking zones4 zone(s)
Number of electric cooking zones0 zone(s)
Oven sizeLarge
Cleaning typeCatalytic
Oven positionBottom
Number of ovens2
Number of shelves2 shelves
Oven net capacity76 L
Oven gross capacity83 L
Energy consumption (conventional)1.64 kWh
Oven 2 energy consumption (conventional)1.38 kWh
Oven 2 sizeSmall
Oven 2 positionTop
Oven 2 net capacity32 L
Oven 2 number of shelves1 shelves
Oven timer typeDigital
Weight and Dimensions IconWeight and Dimensions
Width600 mm
Height900 mm

Related product manuals