Hotpoint MAC155 User Manual

14
WATER DRAINAGE
When the unit is in cooling mode, unwanted water is extracted from the air. Most of this water is used to cool
the unit and make it run more efficiently. When the unit is used in extremely humid environments, water will
collect in a water container at the bottom of the unit. When the water container is full, the compressor will
stop but the fan will continue to run.
When the water container is full, the unit will display ‘ ’ on the control panel until the tank is emptied.
To resume operation, empty the water container according to the following steps:
1. Turn the unit off. Do not move the unit when the water container is full.
2. Place the drain pan accessory under the drainage port at the back of the unit.
3. Remove the rubbe
r
p
lug from the drain hole. The condensate wate
r
will drain out automatically.
When the drain pan is full, replace the rubber plug into the drainage hole to stop the water flow.
Empty the drain pan. Repeat until all the water is emptied.
4. Once the wate
r
containe
r
has
b
een emptied, replace the rubbe
r
p
lug into the drain hole firmly. Do not
allow the water to drip continuously into the drain pan, as it might easily overflow.
DRAINING INTO THE DRAIN PA
N
CONTINUOUS DRAINAGE

Hotpoint MAC155 Specifications

General

Brand	Hotpoint
Model	MAC155
Category	Air Conditioner
Language	English