5
Notes:
• To return the calculator to its default settings, as
indicated below press
(Mode) in
that order. The default settings are:
Calculation mode: COMP
Angle unit: Deg
Exponent display format: Norm 2
Fraction display: a b/c
Decimal point character: Dot
• The mode indicator appears in the upper part of the
display.
• Before calculating, check the current mode setting
(COMP, REG, or SD) and the angle unit (Deg, Rad,
or Grad).
Input Limit
• The memory of the calculator can accommodate 79
steps in any one calculation. When you press a
number key or an arithmetic operator key (
,
, , ), it occupies on step. Pressing or
does not occupy a step. So pressing ,
for example, takes up only one step.
• When you input the 73rd set of any calculation, the
cursor changes from “_” to “” to alert you to the
fact that the capacity of the memory is almost used
up. If what you want to input contains more than 79
steps, separate the calculation into two or more
smaller calculations and then combine them as you
go.
•Press
to recall the previous result, which can
then be used in the next calculation. Please see
the section on Key Memory for more information
about the
key.
To Next Page
Loading...
Need help?
General
