2. Pull the drive away from the socket to remove it (2).
To install the solid-state drive, reverse the removal procedures.
NOTE: Solid-state drives are designed with a notch to prevent incorrect insertion.
Memory modules
To remove the memory modules, use this procedure and illustration.
Table
5-5 Memory module descriptions and part numbers
Description Spare part number
Memory module, 8 GB (DDR4-3200) L46598-005
Memory module, 4 GB (DDR4-3200) L83673-005
Before removing the memory, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 27).
2. Remove the bottom cover (Bottom cover on page 27).
3. Remove the battery (see Battery on page 29).
If you are replacing a memory module, remove the existing memory module:
▲ Spread the two retention clips outward (1) until the memory module tilts up at a 45° angle, and then
remove the module (2). Use the same procedure to remove all memory modules.
IMPORTANT: To prevent damage to the memory module, hold the memory module by the edges only.
Do not touch the components on the memory module.
Component replacement procedures 33
To Next Page
Loading...
Need help?
General
