Time Zone
The Time Zone page is used to configure your local time zone. The switch must be configured to
acquire the time from an SNTP server. An acronym can also be assigned to a selected time zone.
No time zone is configured by default.
To display the Time Zone page, click Network Setup > Time Zone in the navigation pane.
Figure 17 Time Zone Page
Table 14 Time Zone Fields
DescriptionField
Select the time zone for your location.Time Zone
Specify an acronym for the time zone.Acronym
• Click Apply to save any changes for the current boot session; the changes take effect
immediately.
• Click the Refresh link above the page to re-display the page with current settings from the
switch.
To view a summary of clock and time zone information, click Status > Clock in the navigation pane.
Daylight Saving Time
The Daylight Saving Time page is used to configure if and when Daylight Saving Time (DST) occurs
for your time zone. When configured, the system time will adjust automatically during Daylight
Saving Time.
To display the Daylight Saving Time page, click Network Setup > Daylight Saving Time in the
navigation pane.
The page displays differently depending on the mode selected in the Daylight Saving Time field.
In the following figure, the mode is set to Recurring.
28 Network Setup
To Next Page
Loading...
Need help?
General
