HP 24mq User Manual

22
3) Lift the CN503 connector from the PCB.
4) Place the new component on the PCB. Be sure that it matches the PCB footprint.
5) Solder the new component.
D-SUB connector CN101
Repair the D-SUB connector:
1) Use a soldering iron and a disordering pump to remove as much solder as possible from the
pin.
2) Use a hot air gun to melt the solder on the pins.
3) Lift the CN101 connector from the PCB.
4) Place the new component on the PCB. Be sure that it matches the PCB footprint.
5) Solder the new component.

HP 24mq Specifications

General

Brand	HP
Model	24mq
Category	Monitor
Language	English