HP 415E User Manual

Section П
Paragraphs 2-17 to 2-20
©
ADAPTER
FRAME
эу @
@ INSTRUMENT
SPACER
CLAMP
SPACER
CLAMP
аше
RETAINING.
SCREWS
Figure 2-4. Two Half Modules in Rack Adapter
а. Connect Model 415E to AC source. Set POWER
switch to CHARGE and charge battery for а minimum
of 16 hours or overnight. Note: the battery can be
maintained in the charging state indefinitely without
damaging the battery. It will assume its fullcapacity,
1.25 ampere hour, and no more.
b. Set POWER switch to TEST position, the meter
needle indication should be within the BAT. CHARGED"
area (see Figure 3-1).
2-2
Model 415E
2-17. INSTALLING BATTERY AND INPUT
CONNECTOR.
2-18.
Available
from
Hewlett-Packard
are
parts
re-
quired
for
modifying
any
Model
415E
to
correspond
to
those
instruments
with
Option
01
and/or
Option
02.
A
rechargeable
Battery
Installation
Kit,
hp
Part
Number
00415-606,
contains
the
battery
and
necessary
hard-
ware
for
installation
(corresponds
to
Option
01).
In-
stallation
instructions
are
detailed
in
Appendix
at
rear
of
this
manual.
To
obtain
the
parts
required
for
an
input
connector
on
the
rear
panel
(corresponding
to
Option
02),
order
by
hp
Part
Number
as
found
in
Table
6-1
(listed
under
Option
02).
Instructions
for
instal-
lation
of
this
additional
connector
are
detailed
in
Ap-
pendix
at
rear
of
this
manual.
2-19. REPACKAGING FOR SHIPMENT.
2-20. When returning an instrument to the Hewlett-
Packard Company, use the original packing material
(if foam type) if available or contact an authorized hp
Sales Office for assistance. If this is not possible, first
protect the instrument surfaces by wrapping in heavy
Kraft paper or with sheets of cardboard flat against
the instrument. Then protect the instrument on all
sides (use approximately 4 inches of packing material
designed specifically for package cushioning), pack in
а durable container, mark container clearly for proper
handling, and insure adequately before shipping.
Note
When an instrument is being returned to the
Hewlett-Packard Company for service or ге-
pair, attach atag tothe instrument specifying
the owner and desired action. Allcorrespon-
dence should identify the instrument by model
number and the full (eight-digit) serial number.
02152-1

HP 415E Specifications

General

Brand	HP
Model	415E
Category	Measuring Instruments
Language	English