HP 9x9KS Series Installation Manual

Series 39/40/42 to 52 Field Upgrade
UPGRADE STICKER INSTALLATION
Place the adhesive upgrade sticker on the top rear of compufer cabinet, near the serial number. See Figure 1-5 for the
correct location.
~Pl
I
Model
I
I Warranty
I
UL
CSA
~
'\
\.
I \ I
Figure 1-5. Upgrade Sticker Location (rear view of 39/40/42)
SYSTEM VERIFICATION
I. Reinstall back cover.
2. Plug in AC power cord. Turn on power switch.
3. Execute
CM PI system selftest by typing SELFTEST at the CM P prompt (-». Refer to Section 3 of this manualfor a
description
of the selftest console messages. For additional selftest information, refer to the HP 3000 Series
39/4X/5X System CM PI Selftest Manual (PIN 30090-90005).
4. Run the M DIAG 58 memory diagnostic to verify correct operation ofthe memory subsystem. Refer to the HP 3000
Series
42XP 152/58 M DIAG 5X Memory Diagnostic Manual (PIN 30477-90002) for instructions.
1-9

HP 9x9KS Series Specifications

General

Brand	HP
Model	9x9KS Series
Category	Desktop
Language	English