Setting Power Save
The Power Save function allows you to set an idle time after which
the camera automatically sets to sleep mode to save power. After
a minute of being in sleep mode, the camera eventually turns off
power.
This function is not available in the following instances:
Recording a movie or audio file•
Playing a slideshow/video/audio file•
Using the USB connector•
Setting LCD Save
Enable the LCD Save function to automatically decrease the LCD brightness to conserve battery power. When the
camera is idle for 20 seconds, the LCD darkens. Press any button to resume to normal brightness.
The camera is idle when no buttons are pressed. LCD Save, though enabled, does not function during video •
playback, slideshow, video recording and Pre-Composition scene mode shooting.
Setting Date & Time
Use the Date & Time function to set the date and time of your camera. This function is useful in attaching date
stamps on captured images. Your camera uses a 24-hour time format.
Press the navigation controls to adjust date and time value. By holding down the 1.
or keys, the numeric
values changes continuously.
Press the 2. OK button
to apply changes.
To Next Page
Loading...
Need help?
General
