26
Image appears
blurred,
indistinct, or too
dark.
Brightness setting is too
low.
Open the OSD menu, and select Brightness to
adjust the
brightness scale as needed.
“Check Video Cable”
is displayed on the
screen.
Monitor video cable is
disconnected.
Connect the appropriate video signal cable
between the computer and monitor. Be
sure that the computer power is off while
connecting the video cable.
“Input Signal Out of
Range” is
displayed
on screen.
Video resolution and/or
refresh rate are set higher
than the monitor supports.
Change the settings to a supported setting
(see Preset display
resolutions on page 31).
The monitor does not
enter into a low-
power sleep state.
The monitor's power saving
control is disabled.
Open the OSD menu and select Power,
select Auto-Sleep Mode, and then set
auto-sleep to On.
“OSD Lockout” is
displayed.
The monitor's OSD
Lockout function is
enabled.
Press and hold the Menu button for 10
seconds to disable the OSD Lockout function.
“Power Button
Lockout” is
displayed.
The monitor's Power
Button Lockout feature is
enabled.
Press and hold the Power button for 10
seconds to unlock the power button function.