replacing the primary hard drive, you must remove the four silver and blue 6-32 isolation
mounting guide screws from the old hard drive and install them in the new hard drive.
Figure 6-19 Extra Guide Screw Locations
No. Guide Screw Device
1 Black M3 Metric Screws 5.25-inch Drives
2 Silver 6-32 Standard Screws 3.5-inch Hard Drive in the Top Drive Bay (Bay 4)
3 Silver and Blue 6-32 Isolation Mounting Screws 3.5-inch Hard Drives in the Middle and Bottom Drive Bays
(Bays 5 and 6)
CAUTION: To prevent loss of work and damage to the computer or drive:
If you are inserting or removing a drive, shut down the operating system properly, turn off the
computer, and unplug the power cord. Do not remove a drive while the computer is on or in standby
mode.
Before handling a drive, ensure that you are discharged of static electricity. While handling a drive,
avoid touching the connector.
Handle a drive carefully; do not drop it.
Do not use excessive force when inserting a drive.
Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields
such as monitors or speakers.
If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and
label the package “Fragile: Handle With Care.”
96 Chapter 6 Removal and Replacement Procedures Convertible Minitower (CMT) Chassis
To Next Page
Loading...
Need help?
General