Speaker
Description Spare part number
Speaker 689384-001
The speaker is secured to the front of the chassis between the fan and the I/O ports. Remove the
screws from the outside and then remove the speaker from the inside.
1. Prepare the computer for disassembly (
Preparation for Disassembly on page 207).
2. Remove the computer access panel (
Access Panel on page 208).
3. Remove the front bezel (
Front Bezel on page 209).
4. Disconnect the speaker cable from the white system board connector labeled SPKR.
5. On the outside of the chassis, remove the two Torx T8 screws that secure the speaker to the
chassis (1), and then from the inside of the chassis, slide the speaker up to remove it (2).
Figure 9-24 Removing the speaker
To install the speaker, reverse the removal procedure.
230 Chapter 9 Removal and Replacement Procedures Ultra-Slim Desktop (USDT) Chassis
To Next Page
Loading...
Need help?
General