4. Disconnect the VGA board cable from the bottom of the system board.
5. Remove the system board from the chassis.
Reverse the preceding procedure to install the system board.
RJ-11 connector cable
NOTE: The RJ-11 connector cable is included in the Cable Kit, spare part number 595787-001.
Before removing the RJ-11 connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 47).
5. Remove the following components:
a. Hard drive (see
Hard drive on page 54)
b. Optical drive (see
Optical drive on page 49)
c. Keyboard (see
Keyboard on page 65)
d. Switch cover (see
Switch cover on page 72)
e. Display assembly (see
Display assembly on page 82)
f. Top cover (see
Top cover on page 88)
g. Fan (see
Fan on page 74)
Component replacement procedures 99