32
Configuring routing between an MCE and a PE
MCE-PE routing configuration includes these tasks:
• Binding the MCE-PE interfaces to IPv6 VPN instances.
• Performing routing configurations.
• Redistributing IPv6 VPN routes into the routing protocol running between the MCE and the PE.
Perform the following configuration tasks on the MCE. Configure the PE in the same way that you
configure a PE in a basic IPv6 MPLS L3VPN. For more information about configuring the PE, see
"Configuring MPLS L3VPN."
Configuring IPv6 static routing between an MCE and a PE
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Configure an IPv6
static route for an IPv6
VPN instance.
ipv6 route-static
vpn-instance
s-vpn-instance-name ipv6-address prefix-length
{ interface-type interface-number
[ next-hop-address ] | nexthop-address [
public
] |
vpn-instance
d-vpn-instance-name
nexthop-address } [
permanent
] [
preference
preference-value ] [
tag
tag-value ] [
description
description-text ]
By default, no IPv6
static route is
configured.
3. (Optional.) Configure
the default preference
for IPv6 static routes.
ipv6 route-static default-preference
default-preference-value
The default value is 60.
Configuring RIPng between an MCE and a PE
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create a RIPng process for
an IPv6 VPN instance and
enter RIPng view.
ripng
[ process-id ]
vpn-instance
vpn-instance-name
N/A
3. Redistribute VPN routes.
import-route
protocol
[
process-id
] [
allow-ibgp
] [
cost
cost ]
By default, no routes are
redistributed into RIPng.
4. (Optional.) Configure the
default cost value for
redistributed routes.
default cost
value
The default value is 0.
5. Return to system view.
quit
N/A
6. Enter interface view.
interface
interface-type
interface-number
N/A
7. Enable the RIPng process on
the interface.
ripng
process-id
enable
By default, RIPng is disabled on
an interface.
To Next Page
Loading...
Need help?
General