2-1
2
Installing the Switch
The HP 1820 Switches are easy to install. They come with an accessory kit
that includes the brackets for mounting the switches in a standard 19-inch
telco rack, in an equipment cabinet, and with rubber feet that can be attached
so the switches can be securely located on a horizontal surface. The brackets
are designed to allow mounting of the switches in a variety of locations and
orientations. This chapter shows how to install the switches.
Included Parts
The following components ship with an HP 1820 Switch:
■ Documentation kit
■ Accessory kits:
• Quick Setup Guide
• Safety and Regulatory information
• Software License, Warranty, and Support information
1820-8G and 1820-8G-PoE+ Switch
Kit number 5066-2232
• two rack mounting brackets
• eight 8-mm M4 screws to attach the
mounting brackets to the switch
• four 5/8-inch number 12-24 screws to
attach the switch to a rack
• four rubber feet
Kit number 5066-0621
• three 3/4” (20-mm M4) screws for wall
and under-table mounting
• three wall anchors
• cable tie for power cord
To Next Page
Loading...
Need help?
General
