4. Enable the edge holders for rigid substrate.
5. The edge holders appear in the preview window, with an indicator showing their position on the ruler. Place
the edge holders accordingly on the substrate-advance belt.
Using the left edge holder as a reference
1. Place the left edge holder where you want it. See the installation chapter for more information.
2. When you have installed the left edge holder, install the right edge holder as follows:
● Place the right edge holder at the width of the substrate plus 60 mm (2.4 in).
IMPORTANT: Measurements should be made using the ruler built into the printer.
● Alternatively, place the substrate on the belt, level with the left edge holder, and install the right edge
holder level with the substrate. Once installed, move the right edge holder 20 mm (0.8 in) to the right.
IMPORTANT: Measurements should be made using the ruler built into the printer.
ENWW How to position the edge holders 9
To Next Page
Need help?
General
