The parts shown in the illustrations are provided in the substrate edge holder kit. The print-zone module should
be chosen according to the intended use, for exible or rigid substrate. Look at the icon on each print-zone
module to identify the type of substrate for which it is intended.
To assemble the edge holders, look for a at surface on which to place the parts. Decide whether you will use the
exible or rigid print-zone module.
1. Take one input module and unfold the hinge.
2. Overlap the input module and attach the two parts with the screws provided.
3. Repeat the operation at the other end of the print-zone module, to attach it to the output module.
4. Repeat both operations to assemble the second edge holder.
Once the edge holders are assembled, they can be kept in the box provided, you have only to remove the foam.
IMPORTANT: If you are working with rigid substrates, there are shims to be installed on the edge holders that
help you to handle thicker substrates. See How to install shims on page 4.
ENWW Substrate edge holders setup 3
To Next Page
Loading...
Need help?
General
