EasyManuals Logo
Home>HP>Monitor>LP3065

HP LP3065 User Manual

HP LP3065
33 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Maintenance Guidelines
To enhance the performance and extend the life of your monitor:
Do not open your monitor cabinet or attempt to service this product yourself. Adjust only those
controls that are covered in the operating instructions. If your monitor is not operating properly or
has been dropped or damaged, contact your HP authorized dealer, reseller, or service provider.
Use only a power source and connection appropriate for this monitor, as indicated on the label/
back plate of the monitor.
Be sure the total ampere rating of the products connected to the outlet does not exceed the current
rating of the electrical outlet, and the total ampere rating of the products connected to the cord does
not exceed the rating of the cord. Look on the power label to determine the ampere rating (AMPS
or A) for each device.
Install your monitor near an outlet that you can easily reach. Disconnect the monitor by grasping
the plug firmly and pulling it from the outlet. Never disconnect the monitor by pulling the cord.
Turn your monitor off when not in use. You can substantially increase the life expectancy of your
monitor by using a screen saver program and turning off the monitor when not in use.
Slots and openings in the cabinet are provided for ventilation. These openings must not be blocked
or covered. Never push objects of any kind into cabinet slots or other openings.
Do not drop your monitor or place it on an unstable surface.
Do not allow anything to rest on the power cord. Do not walk on the cord.
Keep your monitor in a well-ventilated area, away from excessive light, heat or moisture.
When removing the monitor base, you must lay the monitor face down on a soft area to prevent it
from getting scratched, defaced, or broken.
Cleaning the Monitor
1. Turn off the monitor and the computer.
2. Unplug the monitor from the wall outlet.
3. Clean the monitor plastics with a clean cloth dampened with water.
4. Clean the monitor screen with an antistatic screen cleaner.
CAUTION Do not use benzene, thinner, ammonia, or any other volatile substances to clean
your monitor or the screen. These chemicals may damage the cabinet finish as well as the screen.
Shipping the Monitor
Keep the original packing box in a storage area. You may need it later if you move or ship your monitor.
ENWW Maintenance Guidelines 3

Table of Contents

Other manuals for HP LP3065

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP LP3065 and is the answer not in the manual?

HP LP3065 Specifications

General IconGeneral
Pixel pitch0.250 mm
Response time6 ms
Display diagonal30 \
Display resolution2560 x 1600 pixels
Contrast ratio (typical)1000:1
Display number of colors16.78 million colors
Display scanning frequencyHorizontal frequency: 100 kHz, Vertical frequency: 60 Hz
Display brightness (typical)300 cd/m²
Supported graphics resolutions2560 x 1600 (WQXGA)
UNSPSC-code43211902
On/off switchYes
Audio includedNo audio includedNo audio included at platform level
Security featuresKensington Lock-ready
Weight (imperial)Unpacked30.6 lb lbs
Power requirementsAuto-Sensing, 100 to 240 VAC, 50 +/-3 Hz to 60 +/-3 Hz)
Display resolution at frequency2560 x 1600 @ 60 Hz (native)
Dimensions (W x D x H) (imperial)27.2 x 3.3 x 17.9 \
Product dimensions (with stand, imperial)27.2 x 9.5 x 23.2 \
Storage temperature (T-T)-10 - 60 °C
Operating temperature (T-T)10 - 35 °C
Operating relative humidity (H-H)20 - 80 %
Non-operating relative humidity (non-condensing)5 - 85 %
Tilt angle range-5 - 30 °
Height adjustment100 mm
Cable lock slot typeKensington
Panel mounting interface100 x 100 mm
Power consumption (standby)2 W
Power consumption (typical)118 W
CertificationAustralian ACA Approval, Canadian Requirements/CSA, CE Marking, China CCIB/CCEE Approval, CISPR Requirements, Eastern European Approvals, FCC Approval, German Ergonomic (TUV and GS Mark), ISO 9241-3, 7, 8 VDT Guidelines, ISO 13406-2 Pixel Defect Guidelines, Mexican NOM Approval, MIC Requirements (New Zealand), MPR-II Compliant, Nordic Approvals (Nemko, Fimko, Demko, Semko), S. Korean MIC Approval, Taiwan BSMI Approval, TCO 99 (emissions, ergonomics, environment), TUV-Ergo, UL Listed, VCCI Approvals, Microsoft Windows Certification (Microsoft Windows 98, Microsoft Windows 2000, and Microsoft Windows XP)
Product colorBlack
Country of originChina
I/O portsOne upstream, four downstream USB 2.0 Hub ports (cable included)
USB hub version2.0
DVI-D ports quantity3
DVI-I ports quantity0
USB upstream port typeUSB Type-B
USB Type-A downstream ports quantity4
Weight and Dimensions IconWeight and Dimensions
Depth (with stand)240 mm
Height (with stand)590 mm
Weight (with stand)13400 g
Depth (without stand)84 mm
Width (without stand)692 mm
Height (without stand)455 mm

Related product manuals