HPE OfficeConnect 1920S Switch Series Quick Setup
Guide and Safety/Regulatory Information
Applicable products
HPE OfficeConnect 1920S 8G Switch JL380A
HPE OfficeConnect 1920S 24G 2SFP Switch JL381A
HPE OfficeConnect 1920S 48G 4SFP Switch JL382A
HPE OfficeConnect 1920S 8G PPoE+ 65W Switch JL383A
HPE OfficeConnect 1920S 24G 2SFP PPoE+ 185W Switch JL384A
HPE OfficeConnect 1920S 24G 2SFP PoE+ 370W Switch JL385A
HPE OfficeConnect 1920S 48G 4SFP PPoE+ 370W Switch JL386A
HPE OfficeConnect 1920S 8G 2SFP PoE+ 185W Switch JL582A
HPE OfficeConnect 1920S 24G 2SFP PoE+ 185W Switch JL583A
HPE OfficeConnect 1920S 48G 4SFP PoE+ 370W Switch JL584A
Use only supported HPE Aruba SFP transceivers
Non-HPE Aruba SFP transceivers are not supported. Use of supported HPE Aruba products ensures that your network
maintains optimal performance and reliability. If you require additional transceivers, contact an HPE Aruba sales
representative or an authorized reseller. For more information, see the latest edition of the Installation and Getting Started
Guide for your switch at http://www.hpe.com/networking/ResourceFinder.
Installation Precautions
WARNING:
• Adequately secure the rack or cabinet to prevent it from becoming unstable, tilting, or falling. Mount devices
installed in a rack or cabinet as low as possible, with the heaviest devices at the bottom, and progressively lighter
devices above.
• Do not wall-mount any switch without checking for restrictions in the Installation and Getting Started Guide at
http://www.hpe.com/networking/ResourceCenter. Wall-mount the switch with network ports facing up or down
(away from or toward the floor). Do not wall-mount the switch with the ventilation holes facing up or down.
*5200-4911*
©
Copyright 2017, 2018, Hewlett Packard Enterprise Development LP
Part Number: 5200-4911
Published: March 2018
Edition: 1, Printed in China
To Next Page
Need help?
General