Hard drive
NOTE: The hard drive spare part does not include the hard drive bracket (929561-001) or connector cable
(929450-001).
Description Spare part number
2 TB, 5400 rpm, 7mm (for use only in a dual storage conguration with the 256 GB solid state drive) 929167-850
2 TB, 5400 rpm + 8 GB NAND Hybrid, 7mm 929167-850
1 TB, 7200 rpm, 9.5mm 766644-001
Hard drive bracket kit 929561-001
Hard drive connector cable 929450-001
IMPORTANT: Make special note of each screw and screw lock size and location during removal
and replacement
Before removing the hard drive, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see Battery on page 33).
Remove the hard drive:
1. Release the hard drive connector cable from the zero insertion force (ZIF) connector (1) on the system
board.
2. Remove the hard drive connector cable from the ZIF connector (2).
3. Lift the top edge of the hard drive upward (3).
Component replacement procedures 35