54
Display
(HP Authorized Service Providers Only)
Required Equipment
• Appropriate ESD station
• Torx #6 screwdriver
• 5mm Hexdriver
• Two small flat tip screwdrivers (or similar prying devices)
• Probe
Removal Procedure
1. Remove the battery, ac adapter, mass storage, system card (if applicable), memory module
(if installed), modem (if installed), mouse, and any installed PCMCIA accessory cards.
2. Remove the four Rubber Feet and seven Screws from the bottom case (see below
illustration).
Figure 9 - Outer Bottom Case Components
Screw
M2x4.6mm(T6)
(Qty 6)
Rubber Foot
(Qty 4)
Door - Battery
Battery
To Next Page
Loading...
Need help?
General