2-26 Removal and Replacement HP Omnibook 6000/6100
Figure 2-18. Removing the Motherboard: Omnibook 6000 Models
Reassembly Notes
All Models
• Omnibook 6100 models only: Replace the sound/IR panel before replacing the motherboard.
• Insert the audio connectors through their openings in the bottom case, then lower the motherboard
into place.
• When reinstalling the sound/IR panel, make sure the volume control is oriented properly (pins
facing inward). Insert the tabs on the end of the panel into the slots in the bottom case.
• Omnibook 6000 models only: When installing the vent panel, insert the pin on the back end of the
panel under the bracket on the bottom case.
• Wireless models only: Before installing the motherboard, make sure the round coax cable from
the front antenna PCA is held by the clips in the bottom case. Reconnect the front antenna PCA
flex cable before reinstalling the top case. To reinstall the rear antenna PCA, place the PCA in its
position near the left hinge, replace the screw, then thread the cable through to the bottom of the
computer and reconnect the cable to mini-PCI card #1.
Screws, M2.5x6mm (3)
Screws, M2x15mm (2)
Screws, M2.5x4mm (3)
To Next Page
Loading...
Need help?
General