4. Remove the WLAN antenna cables from the channel (2) located between the wireless module
compartment and the memory module compartment.
5. Turn the computer right-side up, with the rear panel toward you.
6. Open the computer as far as possible.
7. Disconnect the display panel cable (1) from the system board and remove the cable from the cavity
between the system board and the display left hinge.
8. Disconnect the webcam/microphone module cable (2) from the system board.
9. Remove the WLAN antenna cables (3) from the clips and routing channel built into the top cover.
CAUTION: Support the display assembly when removing the following screws. Failure to support
the display assembly can result in damage to the display assembly and other computer
components.
10. Remove the two Phillips PM2.5×7.0 screws (1) that secure the display assembly to the computer.
64 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
Need help?
General