Display assembly
Description Spare part number
13.3-inch, WXGA BrightView display assembly for use in dv3000 models (includes webcam/
microphone module, webcam/microphone module cable, 2 microphones, and 3 wireless antenna
transceivers and cables)
468806-001
13.3-inch, WXGA BrightView display assembly for use in dv3500 models with an LCD display
(includes webcam/microphone module, webcam/microphone module cable, 2 microphones, and 3
wireless antenna transceivers and cables)
496107-001
13.3-inch, WXGA BrightView display assembly for use in dv3500 models with an LED display
(includes webcam/microphone module, webcam/microphone module cable, 2 microphones, and 3
wireless antenna transceivers and cables)
496108-001
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 43).
5. Disconnect the wireless antenna cables from the WLAN module (see
WLAN module on page 45).
6. Remove the following components:
a. Keyboard (see
Keyboard on page 54)
b. Switch cover (see
Switch cover on page 57)
c. Top cover (see
Top cover on page 58)
Remove the display assembly:
1. Close the computer.
2. Turn the computer upside down, with the rear panel toward you.
3. Remove the two Phillips PM2.5×7.0 screws (1) that secure the display assembly to the computer.
Component replacement procedures 63
To Next Page
Loading...
Need help?
General