5. Lift the cover (3), and then remove the back cover (4).
Reverse this procedure to install the back cover.
Battery
Description Spare part number
Battery, 2 Cell 37 WHr. 9.75 Ah, USB-charging (includes cable) 799168-001
Before removing the battery, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off, turn the tablet on, and then shut it down
through the operating system.
2. Disconnect the power from the tablet by unplugging the power adapter cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the back cover (see
Back cover on page 14).
WARNING! To reduce potential safety issues, use only the battery provided with the tablet, a replacement
battery provided by HP, or a compatible battery purchased from HP.
CAUTION: Removing a battery that is the sole power source for the tablet can cause loss of information. To
prevent loss of information, save your work or shut down the tablet through the operating system before
disconnecting and removing the battery.
Remove the battery:
NOTE: Disconnect the battery cable carefully; pulling too hard can break the system board connector.
1. Disconnect the battery cable (1) from the system board.
2. Release the battery tabs and tape holding the battery.
NOTE: Be careful not to bend the battery as you lift it.
Battery 15
To Next Page
Loading...
Need help?
General
