To Next Page

To Previous Page

NOTE:

This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are

ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on CTO

product offerings and requirements.

NOTE:

Configure-to-order (CTO) servers must start with a CTO Chassis.

NOTE:

FIO indicates that this option is only available as a factory installable option.

Step 1: Base Configuration (choose one of the following configurable models)

Hot Plug LFF Models

HP ProLiant DL180 G6 LFF Configure-to-order Rack Server

507168-B21

Factory Integrated Model ships with:

HP NC362i Integrated Dual Port Gigabit Server Adapter

Three available PCI-Express slots:

Slot 1: x16 low-profile/half-height slot

Optional Slots 2, 3, & 4: 2x8 full-height/full length, 1x4 full-height/full length

(Recommended)

NOTE:

Optional PCI-X option kit includes: Slot 1 and 2: full-length/full-height PCI-X 100.

PCI-X slots are 64 bits; 133 MHz capable if only one PCI-X card is installed in the server.

NOTE:

Optional FL/FH option kit includes: Slot 1: full length/full height slot.

One HP SATA Embedded Cable Kit

One Highline IEC Power Cord

4 Non-Hot Plug Fans

Rack (2U), (3.5 in/8.89 cm)

Tool-less Fixed Rails

Hot Plug SFF Models

HP ProLiant DL180 G6 SFF Configure-to-order Server

594911-B21

Factory Integrated Model ships with:

HP NC362i Integrated Dual Port Gigabit Server Adapter

Three available PCI-Express slots:

Slot 1: x16 low-profile/half-height slot

Optional Slots 2, 3, & 4: 2x8 full-height/full length, 1x4 full-height/full length

(Recommended)

NOTE:

Optional PCI-X option kit includes: Slot 1 and 2: full-length/full-height PCI-X 100.

PCI-X slots are 64 bits; 133 MHz capable if only one PCI-X card is installed in the server.

NOTE:

Optional FL/FH option kit includes: Slot 1: full length/full height slot.

One HP SATA Embedded Cable Kit

One Highline IEC Power Cord

4 Non-Hot Plug Fans

Rack (2U), (3.5 in/8.89 cm)

QuickSpecs

HP ProLiant DL180 Generation 6 (G6)

Configuration Information - Factory Integrated Models

DA - 13248 North America — Version 53 — September 24, 2012

Page 18

Questions and Answers:

Need help?

Do you have a question about the HP ProLiant DL180 Generation 6 (G6) and is the answer not in the manual?

HP ProLiant DL180 Generation 6 (G6) Specifications

General

Storage	Up to 12 LFF or 25 SFF drives
Form Factor	2U Rack
Chipset	Intel 5520 Chipset
Processor	Intel Xeon 5500 and 5600 series
Network	Embedded NC382i Dual Port Gigabit Ethernet
Power Supply	Dual 460W or 750W hot-plug power supplies
Operating System Support	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware
RAID	Integrated HP Smart Array P410 Controller (RAID 0/1/1+0/5) with optional battery-backed write cache (BBWC) or Flash-Backed Write Cache (FBWC). Optional HP Smart Array P212 Controller (RAID 0/1/1+0)