Installation of the HP Lights-Out 100c Remote Management Card 9
Installing the remote management card
1. Remove the access panel.
2. Carefully lay the server on its unexposed side to gain access to the system board.
3. Locate the remote management card connectors on the system board.
4. Install the remote management card in the connectors on the system board.
Post-installation procedures
1. Be sure all components are installed according to the installation procedures.
2. Be sure you have not left any loose tools or parts inside the server.
3. Reinstall any expansion boards, peripherals, board covers, and system cables previously removed.
4. Reinstall the system covers.
5. Connect all external cables and the AC power cord to the system.
6. Press the power button on the front panel to power on the server.
To Next Page
Loading...
Need help?
General