The innovative Minimally Switched Technology used in the HP R5000 UPS improves the performance over traditional line-interactive
UPS designs while reducing the cost, weight, and size of traditional double-conversion online UPS designs. The digital signal processing
(DSP) enables complete digital control of the UPS resulting in increased power conditioning, lower system cost, and enhanced user
interface interactivity.
DSP technology enables the practical implementation of sophisticated UPS topologies and controls. The DSP can simultaneously control
multiple power converters to optimize system efficiency and other performance characteristics such as: enhanced battery management
for extended battery life, and improved output voltage regulation. The result is a higher performance UPS in smaller, lighter, more
reliable designs-an advantage for space-constrained equipment racks and cost conscious, co-located data center applications.
Front View:
Rear View:
1.
Escape Button
1.
ERM connector for the small plug on the split ERM cable
2.
Scroll up button
2.
Load segment 1 circuit breaker (controls the C19 and C13
receptacles, but does not control the large output receptacle)
3.
Scroll down button
3.
Load segment 1 (two IEC-320-C19 receptacles, two IEC-320-
C13 receptacles)
4.
Enter/Select button
4.
Cord retention clip attachment locations
5.
Power button
5.
Load segment 2 (two IEC-320-C19 receptacles and two IEC-
320-C13 receptacles)
6.
REPO port
7.
USB communications port
8.
Serial communications port
9.
HP UPS Network Module (included)
10.
Ground bonding screw
11.
Input power line cord with NEMA L6-30 plug
12.
Load segment 2 circuit breaker
13.
Large output NEMA L6-30R receptacle or IEC-309-32A
receptacle associated with load segment 1
14.
ERM Connector for large plug
QuickSpecs
R5000 Uninterruptible Power System (UPS)
Overview
DA - 14109 North America — Version 5 — November 1, 2013
Page 1
To Next Page
Need help?
General
