Technical Specifications
User Guide B–7
Entering User Modes
The video controller signal may occasionally call for a mode that
is not preset if:
■ You are not using a standard graphics adapter.
■ You are not using a preset mode.
If this occurs, you may need to readjust the parameters of the
monitor screen by using the on-screen display. Your changes can
be made to any or all of these modes and saved in memory. The
monitor automatically stores the new setting, then recognizes the
new mode just as it does a preset mode. In addition to the 15
factory preset modes, there are four user modes that can be
entered and stored.
Energy Saver Feature
When the monitor is in its normal operating mode, the monitor
uses less than 40 watts of power and the Power light is green.
The monitor also supports a reduced power state. The reduced
power state will be entered into if the monitor detects the absence
of either the horizontal sync signal and/or the vertical sync signal.
Upon detecting the absence of these signals, the monitor screen is
13 1152 x 900 71.7 76.1
14 1280 x 1024 64.0 60.0
15 1280 x 1024 80.0 75.0
* Modes 12, 13, 14, and 15 apply to 1706 and 1906 models only
Factory Preset Display Modes (Continued)
Preset Pixel Format Horz Freq (kHz) Vert Freq (Hz)
To Next Page
Loading...
Need help?
General
