To Next Page

To Previous Page

2) Use a hot air gun to melt the solder on the pins.

3) Lift the CN551 connector from the circuit board.

4) Place the new component on the circuit board. Be sure that it matches the footprint.

5) Solder the new component.

Audio Connector CN601

Repair the DP connector:

1) Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.

2) Use a hot air gun to melt the solder on the pins.

3) Lift the CN601 connector from the circuit board.

4) Place the new component on the circuit board. Be sure that it matches the footprint.

5) Solder the new component.

Questions and Answers:

Need help?

Do you have a question about the HP X27c and is the answer not in the manual?

HP X27c Specifications

General