To Next Page

To Previous Page

HDMI Connector repair- J12, H13

1) Use a soldering iron and a de-soldering pump to remove as much solder as possible from

one of the pin.

2) Use a hot air gun to melt the solder on the pins

3) Lift connector from the PCB

4) Place new component on the location, and must check it can match PCB footprint

5) Soldering the new component by solder iron

6) Please must stick a gasket on the Shielding.

Questions and Answers:

Need help?

Do you have a question about the HP Z27 G2 Series and is the answer not in the manual?

HP Z27 G2 Series Specifications

General