To Next Page

To Previous Page

IMPORTANT:

• Repair Condition: Connector repair is only for out of warranty.

• Repairing must operate by professional repairers (Note) in repair center, not

applicable for end user.

• Electrostatic protection is required when component replacement is required.

• The monitor meets ROHS, please use Lead-free solder wire for soldering.

• If Connector need to replace, must check specification and part number whether

match the BOM and location.

• If connector need to replace, please insert new parts carefully because the near

pin may cause short circuit by inappropriate operate.

• DO NOT allow any liquid on the board. Water and moisture may cause short-

circuit to the electronic components and lead to malfunctions.

• The fusion point of Lead-Free solder is requested. Repairing with conventional

lead wire may cause damage.

• Work quickly to avoid overheating the circuit board as soon as you confirm the

steady soldering condition.

• Keep the soldering iron tip clean and well tinned and when replacing parts.

• A close inspection of the circuit board revealed look in good condition.

• After repaired, must connect source to each port to check Main board function is

ordinary.

Note: (The requirement of professional repairers’ regulation by ERP lot5)

(1) The professional repairer has the technical competence to repair electronic

displays and complies with the applicable regulations for repairers of electrical

equipment in the Member States where it operates. Reference to an official

registration system as professional repairer, where such system exists in the

Member States concerned, shall be accepted as proof of compliance with this

point.

(2) The professional repairer is covered by insurance covering liabilities resulting from

its activity, regardless of whether this is required by the Member State.

Questions and Answers:

Need help?

Do you have a question about the HP Z34c G3 and is the answer not in the manual?

HP Z34c G3 Specifications

General

Panel type	VA
Pixel pitch	0.2325 x 0.2325 mm
Aspect ratio	21:9
Response time	8 ms
Display surface	Matt
Display diagonal	34 \
Display technology	LED
Vertical scan range	59 - 61 Hz
Maximum refresh rate	60 Hz
Horizontal scan range	88 - 90 kHz
Screen curvature rating	1900R
Contrast ratio (typical)	1000:1
Display number of colors	16.78 million colors
Display brightness (typical)	350 cd/m²
Supported graphics resolutions	720 x 400, 1600 x 900, 2560 x 1440, 1024 x 768 (XGA), 1280 x 1024 (SXGA), 1280 x 720 (HD 720), 1366 x 768, 1440 x 900 (WXGA+), 1680 x 1050 (WSXGA+), 1920 x 1080 (HD 1080), 640 x 480 (VGA), 800 x 600 (SVGA)
HDCP	Yes
DisplayPort version	1.4
USB upstream port type	USB Type-B
VGA (D-Sub) ports quantity	0
USB Type-A downstream ports quantity	4
Power consumption (max)	250 W
Power consumption (standby)	0.5 W
Power consumption (typical)	60 W
Package depth	226 mm
Package width	952 mm
Package height	504 mm
Package weight	16600 g
Tilt angle range	-5 - 10 °
Panel mounting interface	100 x 100 mm
Product color	Black, Silver
Market positioning	Business
Megapixel	5 MP
RMS rated power	5 W
Number of speakers	2
Sustainability certificates	EPEAT Silver, ENERGY STAR

Weight and Dimensions