To Next Page

To Previous Page

6. Attach the mounting plate to the wall or swing arm of your choice.

Figure 3-16 Installing the Mounting Plate

CAUTION: This monitor supports the VESA industry standard 100 mm mounting holes. To

attach a third-party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long

screws are required. Longer screws must not be used because they may damage the monitor. It is

important to verify that the manufacturer’s mounting solution is compliant with the VESA standard

and is rated to support the weight of the monitor display panel. For best performance, it is

important to use the power and video cables provided with the monitor.

7. Place the panel on the mounting bracket you've installed by aligning its recess with the mounting

bracket, then sliding it down over the top of the bracket and pressing it back into place against

the bracket. The release latch on the monitor will pop up when the monitor is safely locked in

place.

Locating the Information Card (Select Models)

Figure 3-17 The Pull-out Information Card

The ZR2240w, ZR2440w, and ZR2740w models provide a card with the information you will need

when contacting HP for support. The card pulls out from behind the USB connectors on the left side of

the panel.

ENWW

Locating the Information Card (Select Models)

Other manuals for HP ZR2440w

Questions and Answers:

Need help?

Do you have a question about the HP ZR2440w and is the answer not in the manual?

General

3D	No
Pixel pitch	0.270 x 0.270 mm
Aspect ratio	16:10
Response time	6 ms
Display surface	Matt
Display diagonal	24 \
Display resolution	1920 x 1200 pixels
Viewable size diagonal	611.3 mm
Contrast ratio (dynamic)	2000000:1
Contrast ratio (typical)	1000:1
Display number of colors	-
Digital vertical frequency	24 - 60 Hz
Digital horizontal frequency	24 - 80 kHz
Display brightness (typical)	350 cd/m²
Supported graphics resolutions	1920 x 1200 (WUXGA)
HDCP	Yes
USB hub version	2.0
DVI-D ports quantity	1
USB Type-A downstream ports quantity	4
Ethernet LAN (RJ-45) ports	0
Tilt angle range	-5 - 35 °
Height adjustment	100 mm
Panel mounting interface	100 x 100 mm
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.5 W
Power consumption (typical)	48 W
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Cables included	DisplayPort, DVI, USB
Certification	EPEAT Gold, CB, CE, FCC, ETLus, VCCI, C-tick, BSMI, TUV-S, ISO9241-307, TUV-GS, CCC, CECP, CEL, NOM, PSB, KC, GOST, ISC
Country of origin	China
Compliance industry standards	TCO 5.0
Sustainability certificates	ENERGY STAR