HTP SSC-80 User Manual

lp-65 Rev. 002 Rel. 010 Date 10.11.19
12
Part 6 - Maintenance and Troubleshooting
Periodic maintenance should be performed by a qualied service technician to ensure all equipment is operating safely and eciently. The
owner should make necessary arrangements with a qualied heating contractor for periodic maintenance of the heater. Installer must also
inform the owner that the lack of proper water heater care and maintenance may result in hazardous conditions.
Annual Maintenance Activities Date Last Completed
Piping 1st Year 2nd Year 3rd Year 4th Year
Near heater piping Check heater and system piping for any sign of leakage; make sure
pipes are properly supported.
System
Visual Do a full visual inspection of all system components. Ensure all
components (including boilers, water treatment systems, mixing
valves, circulators, etc.) are operating properly and have been
maintained.
Functional Test all functions of the system. Perform any maintenance required
by local codes. Verify system pressure is in the safe operating range.
Temperatures Check control for temperature accuracy.
*Verify safe settings on Mixing Valve (if installed in system).
Electrical
Smoke and CO
Detectors
*Verify devices are installed and working properly. Change batteries
if necessary.
Circuit Breakers Check to see that the circuit breaker is clearly labeled. Exercise circuit
breaker.
Connections Check wire connections. Make sure they are tight.
Anode Rod
Remove and visually inspect the anode rod. Anode rod should be
replaced when more than 6” of core wire is exposed at either end of
the rod.
Relief and Drain Valve
Relief Valve Lift and release the relief valve on the water heater. Make certain
that the valve operates properly by allowing several gallons to ush
through the discharge line. Replace if valve is blocked or does not
operate properly.
NOTE: TAKE CAUTION WHEN OPERATING RELIEF VALVE. DISCHARGED
WATER MAY PRESENT A SCALD RISK.
Drain Valve Open the drain valve and drain a few quarts of water from the
bottom of the tank to ush any hard water deposits. Replace if valve
is blocked or does not operate properly.
NOTE: TAKE CAUTION WHEN OPERATING DRAIN VALVE. DRAINED
WATER MAY PRESENT A SCALD RISK.
Final Inspection
Check for
Combustibles
Check area around heater for combustible materials such as gasoline
or paint thinner. If combustible materials are found, move away from
the heater to a safe location.
Checklist Verify that you have completed the entire checklist. WARNING:
FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY OR DEATH.
Homeowner Review what you have done with the homeowner.
Initial and Date after Inspection / Service. Continue Inspections Annually beyond the
Fourth Year.
Table 5 - Maintenance Activities Checklist - *If Applicable to System

HTP SSC-80 Specifications

General

Brand	HTP
Model	SSC-80
Category	Water Heater
Language	English