Name Type Function
Power button - Powers on or o the service software.
● After the power switch of the device is turned on,
the device automatically enters the running state.
You do not need to press the power button.
● When the power switch is turned on, you can
press the power button and hold it down for 10s
to enter the standby mode. If you press the power
button again, the device enters the running state.
When the device is in standby mode, the power
button indicator is steady blue. When the device
is running, the power button indicator is
o.
Reset button - ● Hold down this button for 1s to reset the system.
● Hold down this button for 10s to restore the
device to factory defaults.
Power cable
port
- Connects the power supply.
Power switch - Powers on or o the device.
Table 2-4 Indicator description
Name
Status Description
Network port ACT indicator ● O: No data is being transmitted.
● Blinking: Data is being transmitted.
Network port LINK indicator ● Steady on: The network port is
connected properly.
● O: The network port is not
connected.
Power-on/o status indicator ● Steady on: The service software is
running.
● O: The service software is not
started.
IVS1800 Video Management System
User Manual 2 IVS1800 Overview
Issue 02 (2021-01-27) Copyright © Huawei Technologies Co., Ltd. 7
To Next Page
Loading...
Need help?
General