Step 2 For details about how to commission cameras and set parameters for them, see
the documentation delivered with the equipment or obtain the documentation by
referring to the "Reference Documentation" section.
1. Preview the site situation in real time and check the camera coverage through
videos. Adjust the lens if necessary.
2. Choose Settings > Network > TCP/IP, and set IPv4 address, IPv4 Subnet
mask, and IPv4 Gateway address for the camera according to the site plan.
3. Choose Settings > Video/Audio/Image > Video Settings, and set camera
stream type, primary stream, and secondary stream 1 parameters, as
shown in the following
gures.
Set the encoding protocol to H.265.
Figure 4-3 Setting primary stream parameters
IVS1800 Video Management System
User Manual 4 Commissioning the IVS1800
Issue 02 (2021-01-27) Copyright © Huawei Technologies Co., Ltd. 20
To Next Page
Loading...
Need help?
General